UPA-USB Logic Analyzer

A logic analyzer can trigger on a complicated sequence of digital events, and then capture a large amount of digital data from the system under test.

Once the probes are connected, the user programs the analyzer with the names of each signal. Next, a capture mode is chosen, where the input signals are sampled at regular intervals based on an internal clock source. After the mode is chosen, a trigger condition may be set. A trigger condition can be triggering on a rising/falling edge or logical "0/1" of a single signal (Trigger input). At this point, the user sets the analyzer to "run" mode. Once the data is captured, it is displayed by waveform window.